Question # 1
You have been asked to onboard a new Aruba 6300M in a customer deployment You are working remotely rather than on-site You have a colleague installing the switch The colleague has provided you with a remote console session to configure the edge switch You have been asked to configure a link aggregation going back to the cores using interfaces 1/1/51 and 1/1/52 The Senior Engineer of the project has asked you to configure the switch and 1Q uplink with these guidelines
1. Add VLAN 20 to the local VLAN database with name Mgmt
2. Add L3 SVl on VLAN 20 for Management using address 10 in the 10.1.1 0/24 subnet 3. Add LAG 1 using LACP mode active for the uplink
4 use vlan 20 as the native vlan on the LAG 5. Make sure the interfaces are all ON.
Which configuration script will achieve the task?
| | A. Edge1# conf t vlan 20 name Mgmt interface vlan 20 ip address 10.1.1.10/24 no shut interface lag 1 shut vlan access 20 lacp mode active Int 1/1/51.1/1/52 shut no routing lag 1 interface lag 1 no shut | | B. Edgel# conf t vlan 20 name Mgmt interface vlan 20 ip address 10 1.1 10/24 no shut interface 1/1/51.1/1/52 shut vlan trunk native 20 vlan trunk allowed all lag 1 lacp
mode active interface 1/1/51.1/1/52 no shut | | C. Edgel# conf t vlan 20 name Mgmt interface vlan 20 ip address 10 1 1 10/24 no shut interface lag 1 shut vlan trunk native 20 vlan trunk allowed all lacp mode active Int 1/1/51.1/1/52 shut no routing lag 1 interface lag 1 no shut interface 1/1/51.1/1/52 no shut | | D. conf t vlan 20 name Mgmt ip address 10 1 1.10/24 no shut interface lag 1 shut vlan trunk native 1 vlan trunk allowed all lacp mode active int 1/1/51.1/1/52 shut no routing interface lag 1 no shut interface 1/1/51.1/1/52 no shut |
C. Edgel# conf t vlan 20 name Mgmt interface vlan 20 ip address 10 1 1 10/24 no shut interface lag 1 shut vlan trunk native 20 vlan trunk allowed all lacp mode active Int 1/1/51.1/1/52 shut no routing lag 1 interface lag 1 no shut interface 1/1/51.1/1/52 no shut
Explanation:
This configuration script will achieve the task as it follows the guidelines given by the Senior Engineer. It creates VLAN 20 with name Mgmt, adds L3 SVI on VLAN 20 with IP address 10.1.1.10/24, creates LAG 1 with LACP mode active for the uplink, uses VLAN 20 as the native VLAN on the LAG, and ensures that the interfaces are all ON.
References:https://www.arubanetworks.com/techdocs/AOS-CX/10.04/HTML/5200-6790/GUID-8F0E7E8B-0F4B-4A3C-AE7F-0F1B5A7F9C5D.html
Question # 2
| Which feature can network administrators use to centralized RF planning and optimization service when using an Aruba mobility master architecture? | | A. Airwave | | B. Client Match | | C. AirMatch | | D. Client Wave |
C. AirMatch
Explanation:
AirMatch is a feature that provides centralized RF planning and optimization service for Aruba wireless networks. It uses cloud-based algorithms and machine learning to optimize the RF performance and user experience.
References:https://www.arubanetworks.com/assets/ds/DS_AirMatch.pdf
Question # 3
| When measuring signal strength, dBm is commonly used and 0 dBm corresponds to 1 mW power.
What does -20 dBm correspond to? | | A. .-1 mW | | B. .01 mw | | C. 10 mW | | D. 1mW |
B. .01 mw
Explanation:
dBm is a unit of power that measures the ratio of a given power level to 1 mW. The formula to convert dBm to mW is: P(mW) = 1mW * 10^(P(dBm)/10). Therefore, -20 dBm corresponds to 0.01 mW, as follows: P(mW) = 1mW * 10^(-20/10) = 0.01 mW
References:https://www.rapidtables.com/convert/power/dBm_to_mW.html
Question # 4
| Which statement about manual switch provisioning with Aruba Central is correct? | | A. Manual provisioning does not require DHCP and requires DNS | | B. Manual provisioning does not require DHCP and does not require DNS | | C. Manual provisioning requires DHCP and does not require DNS | | D. Manual provisioning requires DHCP and requires DNS |
B. Manual provisioning does not require DHCP and does not require DNS
Explanation:
Manual provisioning is a method to add switches to Aruba Central without using DHCP or DNS. It requires the user to enter the switch serial number, MAC address, and activation code in Aruba Central, and then configure the switch with the same activation code and Aruba Central’s IP address.
References:https://help.central.arubanetworks.com/latest/documentation/online_help/content/devices/switches/provisioning/manual-provisioning.htm
Question # 5
| A network technician has successfully connected to the employee SSID via 802 1X Which RADIUS message should you look for to ensure a successful connection? | | A. Authorized | | B. Access-Accept | | C. Success | | D. Authenticated |
B. Access-Accept
Explanation:
The RADIUS message that you should look for to ensure a successful connection via 802.1X is Access-Accept. This message indicates that the RADIUS server has authenticated and authorized the supplicant (the device that wants to access thenetwork) and has granted it access to the network resources. The Access-Accept message may also contain additional attributes such as VLAN ID, session timeout, or filter ID that specify how the authenticator (the device that controls access to the network, such as a switch) should treat the supplicant’s traffic.
The other options are not RADIUS messages because:
Authorized: This is not a RADIUS message, but a state that indicates that a port on an authenticator is allowed to pass traffic from a supplicant after successful authentication and authorization.
Success: This is not a RADIUS message, but a status that indicates that an EAP Extensible Authentication Protocol (EAP) is an authentication framework that provides support for multiple authentication methods, such as passwords, certificates, tokens, or biometrics. EAP is used in wireless networks and point-to-point connections to provide secure authentication between a supplicant (a device that wants to access the network) and an authentication server (a device that verifies the credentials of the supplicant). exchange has completed successfully between a supplicant and an authentication server.
Authenticated: This is not a RADIUS message, but a state that indicates that a port on an authenticator has received an EAP-Success message from an authentication server after successful authentication of a supplicant.
References: https://en.wikipedia.org/wiki/RADIUS#Access-Accept https://www.cisco.com/c/en/us/support/docs/security-vpn/remote-authentication-dial-user-service-radius/13838-10.html https://en.wikipedia.org/wiki/IEEE_802.1X#Port-based_network_access_control
https://en.wikipedia.org/wiki/Extensible_Authentication_Protocol#EAP_exchange
Question # 6
| Based on the "snow ip route" output on an AruDaCX 8400. what type of route is "10.1 20 0/24, vrf default via 10.1.12.2. [1/0]"? | | A. local | | B. static | | C. OSPF | | D. connected |
B. static
Explanation:
A static route is a route that is manually configured on a router or switch and does not change unless it is modified by an administrator. Static routes are used to specify how traffic should reach specific destinations that are not directly connected to the device or that are not reachable by dynamic routing protocols. In Aruba CX switches, static routes can be configured using the ip route command in global configuration mode. Based on the “show ip route” output on an Aruba CX 8400 switch, the route “10.1 20 0/24, vrf default via 10.1.12.2, [1/0]” is a static route because it has an administrative distance of 1 and a metric of 0, which are typical values for static routes.
References: https://en.wikipedia.org/wiki/Static_routing https://www.arubanetworks.com/techdocs/AOS-CX_10_04/NOSCG/Content/cx-noscg/ip-routing/static-routes.htm
https://www.arubanetworks.com/techdocs/AOS-CX_10_04/NOSCG/Content/cx-noscg/ip-routing/show-ip-route.htm
Question # 7
| What is the correct command to add a static route to a class-c-network 10.2.10.0 via a gateway of 172.16.1.1? | | A. ip-route 10.2.10.0/24 172.16.1.1 | | B. ip route 10.2.10.0.255.255.255.0 172.16.1.1 description aruba | | C. ip route 10.2.10.0/24.172.16.11 | | D. ip route-static 10.2 10.0.255.255.255.0 172.16.1.1 |
A. ip-route 10.2.10.0/24 172.16.1.1
Explanation:
The correct command to add a static route to a class-c-network 10.2.10.0 via a gateway of 172.16.1.1 is ip-route 10.2.10.0/24 172.16.1.1 . This command specifies the destination network address (10.2.10.0) and prefix length (/24) and the next-hop address (172.16.1 .1) for reaching that network from the switch. The other commands are either incorrect syntax or incorrect parameters for adding a static route.
References:https://www.arubanetworks.com/techdocs/AOS-CX_10_04/NOSCG/Content/cx-noscg/ip-routing/static-routes.htm
HP HPE6-A85 Exam Dumps
5 out of 5
Pass Your Aruba Certified Campus Access Associate Exam in First Attempt With HPE6-A85 Exam Dumps. Real ACA Campus Access Associate Exam Questions As in Actual Exam!
— 60 Questions With Valid Answers
— Updation Date : 16-Jan-2025
— Free HPE6-A85 Updates for 90 Days
— 98% Aruba Certified Campus Access Associate Exam Passing Rate
PDF Only Price 99.99$
19.99$
Buy PDF
Speciality
Additional Information
Testimonials
Related Exams
- Number 1 HP ACA Campus Access Associate study material online
- Regular HPE6-A85 dumps updates for free.
- Aruba Certified Campus Access Associate Practice exam questions with their answers and explaination.
- Our commitment to your success continues through your exam with 24/7 support.
- Free HPE6-A85 exam dumps updates for 90 days
- 97% more cost effective than traditional training
- Aruba Certified Campus Access Associate Practice test to boost your knowledge
- 100% correct ACA Campus Access Associate questions answers compiled by senior IT professionals
HP HPE6-A85 Braindumps
Realbraindumps.com is providing ACA Campus Access Associate HPE6-A85 braindumps which are accurate and of high-quality verified by the team of experts. The HP HPE6-A85 dumps are comprised of Aruba Certified Campus Access Associate questions answers available in printable PDF files and online practice test formats. Our best recommended and an economical package is ACA Campus Access Associate PDF file + test engine discount package along with 3 months free updates of HPE6-A85 exam questions. We have compiled ACA Campus Access Associate exam dumps question answers pdf file for you so that you can easily prepare for your exam. Our HP braindumps will help you in exam. Obtaining valuable professional HP ACA Campus Access Associate certifications with HPE6-A85 exam questions answers will always be beneficial to IT professionals by enhancing their knowledge and boosting their career.
Yes, really its not as tougher as before. Websites like Realbraindumps.com are playing a significant role to make this possible in this competitive world to pass exams with help of ACA Campus Access Associate HPE6-A85 dumps questions. We are here to encourage your ambition and helping you in all possible ways. Our excellent and incomparable HP Aruba Certified Campus Access Associate exam questions answers study material will help you to get through your certification HPE6-A85 exam braindumps in the first attempt.
Pass Exam With HP ACA Campus Access Associate Dumps. We at Realbraindumps are committed to provide you Aruba Certified Campus Access Associate braindumps questions answers online. We recommend you to prepare from our study material and boost your knowledge. You can also get discount on our HP HPE6-A85 dumps. Just talk with our support representatives and ask for special discount on ACA Campus Access Associate exam braindumps. We have latest HPE6-A85 exam dumps having all HP Aruba Certified Campus Access Associate dumps questions written to the highest standards of technical accuracy and can be instantly downloaded and accessed by the candidates when once purchased. Practicing Online ACA Campus Access Associate HPE6-A85 braindumps will help you to get wholly prepared and familiar with the real exam condition. Free ACA Campus Access Associate exam braindumps demos are available for your satisfaction before purchase order.
Send us mail if you want to check HP HPE6-A85 Aruba Certified Campus Access Associate DEMO before your purchase and our support team will send you in email.
If you don't find your dumps here then you can request what you need and we shall provide it to you.
Bulk Packages
$60
- Get 3 Exams PDF
- Get $33 Discount
- Mention Exam Codes in Payment Description.
Buy 3 Exams PDF
$90
- Get 5 Exams PDF
- Get $65 Discount
- Mention Exam Codes in Payment Description.
Buy 5 Exams PDF
$110
- Get 5 Exams PDF + Test Engine
- Get $105 Discount
- Mention Exam Codes in Payment Description.
Buy 5 Exams PDF + Engine
 Jessica Doe
ACA Campus Access Associate
We are providing HP HPE6-A85 Braindumps with practice exam question answers. These will help you to prepare your Aruba Certified Campus Access Associate exam. Buy ACA Campus Access Associate HPE6-A85 dumps and boost your knowledge.
| 
